Enterasys 2S4082-25-SYS Guida di Installazione Scaricare il pdf (Pagina 102)

Memory Locations and Replacement Procedures

B-2 Mode Switch Bank Settings and Optional Installations

modulenames,areresettothefactorydefaultsettings.Oncethemoduleresets, youcaneither

usethefactorydefaultsettingsorreenteryourownparameters.

•Switch8–ClearAdminPassword.Changingthepositionofthisswitchclearstheadmin

password,andrestoresthefactorydefaultpasswordonthenext

power‐upofthemodule.

Oncethemoduleresets,youcaneitherusethefactorydefaultsettingsorreenteryourown

password.

Figure B-1 Mode Switch Location on the NAC Controller PEP (2S4082-25 shown)

Memory Locations and Replacement Procedures

IntheeventthattheDualIn‐LineMemoryModule(DIMM)orDRAMSingleIn‐lineMemory

Module(SIMM)needstobereplaced,thefollowingsectionsdescribehowtoaccess,locate,and

replacethesememorymodules.Ifyouhavequestionsconcerningthereplacementofeither

memorymodule,referto“Getting 

Help”onpage xviiifordetailsonhowtocontact

Enterasys Networks.

Location of Memory Modules

ThelocationonthemainboardoftheDRAMSIMMandDIMMforboththe2S4082‐25andthe

7S4280‐19arethesame.Figure B‐2showsthelocationsoftheDRAMSIMMandDIMMonthe

mainboardofthe2S4082‐25.

Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to

its factory default setting.

1 Mode switch bank

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 108

Nessun commento

Enterasys 2S4082-25-SYS Guida di Installazione Pagina 102