Enterasys SecureStack A2 A2H124-48P Guida di Installazione Scaricare il pdf (Pagina 32)

Considerations Prior to Installation

3-2 Hardware Installation

Considerations Prior to Installation

Wheninstallingtheswitch,notethefollowing:

•Beforestartingtheinstallation procedure,notifythenetworkadministratorofthe

installation.

•Followtheinstallationprocedures intheorderaspresentedinthisguide.

•DonotconnecttheswitchtothenetworkuntilyouhaveestablishedthecorrectIP

address.

Required Tools

APhillipsscrewdriverisrequiredtoinstalltheswitchintoarack.

Unpacking the Switch

Unpacktheswitchas follows:

1. Opentheboxandremovethepackingmaterialprotectingthesw itch.

2. VerifythatthecontentsofthecartoncontainstheitemslistedinTable 3‐1.

3. Removethetapesealonthenon‐conductivebagtoremovetheswitch.

4. Performavisualinspectionoftheswitchforany

signsofphysicaldamage.Contact

Enterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”on

page 1‐7fordetails.

Table 3-1 Contents of Switch Carton

Item Quantity

A2H124-24P or A2H124-48P switch 1

Mounting kit (two mounting brackets and eight M3x6-mm screws for rack mounting) 1

Rubber feet with adhesive backing for installation on a flat surface 4

AC power cord (The type of power cord is country dependent.) 1

This installation guide 1

Customer Release Notes 1

URL notice card 1

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Nessun commento

Enterasys SecureStack A2 A2H124-48P Guida di Installazione Pagina 32