Enterasys C2RPS-SYS Guida di Installazione Scaricare il pdf (Pagina 35)

Installing the Switch on a Flat Surface

SecureStack A2 Installation Guide 3-7

ToremoveaMini‐GBICfroma portslot,referbacktoFigure3‐1,Figure3‐2,orFigure3‐3,

andproceedasfollows:

1. Attachyourantistaticwriststrap(refertotheinstructionsinyourantistaticwrist

strappackage)beforeremovingtheMini‐GBIC.

2. RemovethecablesconnectedtotheMini‐GBIC.

3. LocatethereleasetabunderthefrontendoftheMini‐GBIC.Forthetypeof

Mini‐GBICshownin:

a. Figure3‐1,

pushdownonthemetalreleasetababovetheconnectorasfaras it

willgotoreleasetheMini‐GBICfromtheportslot.

b. Figure3‐2,pushinonthereleasetabasfarasitwillgotoreleasetheMini‐GBIC

fromtheportslot.

c. Figure

3‐3,pulloutonthereleasetabtoreleasetheMini‐GBICfromtheportslot.

4. GraspthesidesoftheMini‐GBICandpullitstraightoutoftheportslot.

IfstoringorshippingaMini‐GBIC,whichhasafiber‐opticconnector,insertitsprotective

dustcovertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubberfeetis

recommendedtopreventthe

switchfromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to

“InstallingtheRubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage3‐9.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure3‐4andproceedasfollows:

1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethefourrubberfeetfromtheirplasticbagintheshippingbox.

3. Locatethefourmarkedlocationsontheb ottomfourcornersofthechassis.

4. Removetheprotectivestripfromthe

backofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeetintheotherthreelocations.

5. Afterinstallingtherubberfeet,returntheswitchtoitsuprightposition.

6. Proceedto“GuidelinesforFlatSurfaceInstallation

”onpage3‐8.Forarackmount

installation,proceedto“RackMountingtheSwitch”onpage3‐9.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Nessun commento

Enterasys C2RPS-SYS Guida di Installazione Pagina 35